Search models, users, collections, and posts
Surf Pole Holder
IP Report
Print Profile(1)
0.2mm layer, 6 walls, 30% infill
Designer
16.2 h
4 plates
Open in Bambu Studio
Boost
10
33
1
0
12
7
Released
Description
Sand fishing rod holder designed for surf and shore fishing with long rods and heavier setups. Deep auger-style base to screw into sand. Design makes it easier to print on smaller printers and allows sections to adjust for different-sized poles.
After Printing I used Super Glue and a soldering Iron on the connection points to reinforce the holder.
Recommended Settings:
- 4-6 wall loops
- 40-60% infill
- 5 Top & Bottom Shell layer
- Gyroid or cubic infill
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (1)