Billy Cabinet Risers

I purchased a pair of IKEA Billy cabinets to make a FilaBilly, but found the cutout on the back for the baseboards wasn't tall enough to clear my 3" baseboards. I mocked up a set of risers to lift two Billy cabinets 30mm, which was enough to clear my baseboards handily. Includes one for each end of the cabinet and a combined center unit for two side-by-side cabinets. Also included is a flat straight riser which I did not end up printing to save filament, but if you want to you can either use the Cut tool to cut it to size or the scale tool to simply scale it shorter or longer as needed.

I printed this in ABS-GF, 60% tri-hexagon infill and 10 walls. Severely overbuilt, but better than doing it twice. Use your best judgement on strength settings, just know a single Billy with two glass Oxberg doors is nearly 120 pounds empty.