MTG Display Commander Deck Box DOUBLESLEEVED
Copyright Claim
MTG Display Commander Deck Box DOUBLESLEEVED
Boost
10
24
9
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
2.8 h
1 plate
Boost
10
24
9
1
38
51
Released
Description
MTG deck box in which you slide a toploader to display your commander! Fits 100 doublesleeved cards!
Comment & Rating (9)
All
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
Came out perfectly and fits well in my bigger deck cases!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Bit of a weird design where the lid is held on by the friction of rubbing against the toploader, so if you tried to make it not rub, then the lid would just fall off. I think it's fine since the wear on the toploader will be minimal and it's not damaging the card inside but perhaps it could have a better mechanism.
The designer has replied
0
Reply
It’s meant to be a friction fit with the sides of the lid, not the toploader. I wasn’t a huge fan of this design while using it because I thought it was (1/2)
0
Reply
-overly large and bulky. To remove friction fits(which are inconsistent because of different filament types/flow rate) I designed my new box to use magnets. Take a look if you want!
0
Reply
Replying to @Matthewm14
I appreciate the response! I'll definitely check it out. In the meanwhile we're still using this one and it's working just fine :) My A1 mini printed it so that the sides are not where the friction happens, but as I said, it's still working even if not as intended.
(Edited)0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
coming back for each new commander
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The designer has replied
0
Reply
I’m very sorry. What went wrong?
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
(Edited)
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivatives
© 2024 MakerWorld