Fillable door stopper.

I was bored and my door kept closing because of the wind. I designed some super simple door stopper.

You can fill it with water, sand, rocks etc to make it heavier. Print using the .3mf file for settings or look the 3rd picture.

I used a .4mm nozzle default Bambulab PLA settings and eSun PLA+. You need to have tight tolerances if you want to make it water tight (if using water). The bolt is using a flat screwdiver pattern. You might have to play with the Bolt resize to make it fit snug. The .3mf file is using what works in my environment. You can always download the .STL files and rescale them if you need different sizes. You'll need to resize the bolt and the stopper at the same time to make sure the Bolt fits well. If the stopper is sliding when using it on carpet flip the stopper and use the X pattern on top.

The model weight is 66g when filled with water.

BEWARE! : If using PLA to print don't go too hard when trying to screw the bolt for the first time of you WILL strip it.

BEWARE! : Screw the bolt flat with the surface don't go too far or the bolt will fall into the stopper. You'll need to print another bolt.

Good luck!