Flower pot

Spiral flower pot – Modern Minimal Design for 3D Printing

A clean and modern spiral planter designed specifically for FDM 3D printing.
The flowing helical ribs create a soft organic look while also reinforcing the structure of the pot.

This model is optimized to print easily on most consumer 3D printers without supports.

Features

• Modern spiral / helical design
• Minimalistic aesthetic
• Easy to print
• No supports required
• Strong outer structure thanks to spiral ribs
• Smooth inner wall
• Lightweight but rigid construction
• Perfect for indoor plants, succulents, cactus, or decorative use

Printing Recommendations

• Layer height: 0.20 mm
• Wall count: 3–4 perimeters
• Infill: 10–15%
• Supports: Not required
• Material: PLA / PETG recommended
• Seam position: Back or aligned
• Arachne wall generator recommended
• Monotonic top surfaces enabled for cleaner finish

Scaling

The model scales very well.

You can:

• scale it down for small succulents,
• or scale it up for larger plants.

Recommended scaling range:

• 70% → small decorative planter
• 100% → standard desktop planter
• 130–180% → large statement planter

The planter shown in the photo was printed at 70% scale.

Notes

• Increasing the scale also increases wall thickness and overall strength.
• For outdoor use, PETG or ASA is recommended.
• For best visual quality, use matte filament or silk PLA.

Suggested Print Orientation

Print directly on the bottom surface.

No supports needed.