DACHSHUND

Hello there.
This time it's a dachshund figure.
I have printed it in brown because multicolor takes a long time, but if you want it, I can make a multicolor version if you request it in the comments.

It is printed with:
-Layer height 0.16
-Initial layer 0.2
-Aligned Z-seam
-3 wall loops
-15% infill with a gyroid pattern
-Organic tree supports. In this case, I slightly increased the top and bottom Z distance (0.18) to prevent support marks.
For any questions, I am at your disposal in the comments.

Best regards.