Pretty straight forward thing, you need one M3 nut and bolt to mount it.
Probe position is #define NOZZLE_TO_PROBE_OFFSET { 20, 10, -0.9 }
To setup your probe, move the nozzle until it touches the bed, put a ziptie between the probe and the bed tighten the probe nuts.
-0.9 is right on and I only adjust a couple hundreds, You can use -0.8 for your offset if you want to be on the safe side, use babystepping/ liveZ to fine tune your squish at the beginning of your print.
It's obviously best to print this mount in ABS since it's close to the heater bloc.
Printer Brand:
Prusa
Printer:
I3 MK3S
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
20%
Filament:Coex ABS White
Category: 3D Printer Parts