This is a rebuild of BC's Side mount spool holder to make it fit on the Arc case for the P1P and to use the Filler filament hoder from HugoG. Its also compatible with my mod of that holder (https://www.printables.com/model/372594-spool-holder-with-bearing-keeper-and-threaded-end). I also tightened up the connection for the filament arm as it was pretty loose. It was a nice press-fit in PLA with the default Generic profile on the P1P.

It doesn't go all the way to the top screw hole as that gets in the way of the y-connector, but is still held firmly in place.

Before installation, you'll need to remove the screws for the right side of the plexiglass panel as this uses those fittings.

Hardware required:

2x M3x20 bolts for the bottom 2 holes, where the original spool holder was mounted.

2x M3x12 bolts to replace the bolts from the plexiglass.

1x PC4-M10 Pneumatic Connector.

1x Filler filament holder

STEP file included in case you need to make changes.