Stimulant Injector - Escape From Tarkov

The stimulant injector from Escape from Tarkov. The cap is (for the most part) friction fit, allowing it to hold without needed a clip on the inside. I used a spring from a Pilot G-2 Gel Pen to make the push knob be able to be pushed down and come back up. The print is ~144.5mm tall with a diameter of ~14.2mm, modeled off of a Humalog u-100 Kwikpen, which seems to be the inspiration for the injector ingame.

Comes in 3 pieces, the cap, body, and push knob. At the end of the body there is an input for both the spring and the push knob. Put the spring inside, align the notches on the push knob and body, push down and twist to set it in place.

I personally made this with minimal knowledge of Fusion 360, my apologies if isn't up to par.