Peeking Black Cat Bookmark by Kopp3D

Kopp3D

Miniatures>Animals

Print Profile(2)

All

A1 mini

P1S

P1P

X1 Carbon

X1E

0.24mm layer, 2 walls, 15% infill

Designer

43 min

1 plate

4.8(5)

0.24mm layer, 2 walls, 15% infill

50 min

1 plate

5.0(1)

Open in Bambu Studio

Boost

Released

Description

A cute bookmark of a black cat peeking over a fence. Small enough to fit any Bambulab printers.

Edited to make irises pop out a little so there's less color changes and it's easier to colorize in the STL.

Comment & Rating (10)

@GhengisAhn

Hey there, if you can send me the STEP file for this, I'd like to fix the eyes. The black pupils are too flush and when you print with the raw file, it won't color in the eyes properly. The slicer treats the top layer as one whole layer, so whatever the outer finish is, the inner prints that way. I Suggest you either recess the eye down to the base of the cat head where it is black so you don't waste a lot of time on filament changes. or you raise the eye slightly up and that gets printed on its own black layer without filament changes.

The designer has replied

@GhengisAhn

Here is what the print looks like, even though I had colored the pupils black.

@Kopp3D

Replying to @GhengisAhn :

That's interesting! I didn't realize it wouldn't see the pupils in the STL! I made them stick out a little so it would print ok now. I'll upload the raw files+3mf after I run the test to make sure it works well and comment when its good to go.

@Kopp3D

Replying to @GhengisAhn :

It's good to go for download! Thanks again, I'll keep this in mind for my future designs!