Judge Dread Hueforge

Project: Judge Dread_V1_5Colors.hfp

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 108.4x162.6mm in size

You may print at higher layer heights below the Base Thickness of 1.52mm
The Max allowed Thickness is 3.52mm and the Actual Thickness is 3.52mm

    #000000 PLA Sunlu Meta Black  Transmission Distance: 1
    #4c5f71 PLA BambuLab Basic Blue Gray  Transmission Distance: 3
    #ff9016 PLA BambuLab Basic Pumpkin Orange  Transmission Distance: 5.5
    #fce300 PLA BambuLab Basic Yellow  Transmission Distance: 6
    #ffffff PLA Sunlu Meta White  Transmission Distance: 8
This print uses 5 unique filaments

Swap Instructions:
    Start with Black
    At layer #21 (1.76mm) swap to Blue Gray
    At layer #24 (2mm) swap to Pumpkin Orange
    At layer #27 (2.24mm) swap to Yellow
    At layer #31 (2.56mm) swap to White for the rest. (Swap with Black)