Good print! I did print this three times. I didn’t use a brim and it didn’t want to stick at the front where the purge line goes across every print. Hense why my finger is over it at the top. I’m printing it again and I’m gonna try it with a brim and a little higher first layer height.
Hi!, first, thank you for share your print, then, which printer are you using for the lamp ? because I do it in my P1P, and the purge line was only one line, and goes close to the model, but doesn't have any problem. let me know if you need some help.
I used both an X1C and a P1S. It might be that the purged filament didnt wipe off and fall in the chute and ended up on the bed again twice but its all good. Thank you!
A very nice addition to the wall :)
Still need to get some lighting inside it.
Printed perfectly with BL filiment: Bambu Green, Matte Charcoal, and Matte White.