RGG 360 V2 Painting Handle XL Cap 40mm No Supports

A swappable cap for the Redgrass Games RGG 360° V2 handle, sized for 40mm round bases. The bezel is thin enough that bases that are slightly over 40mm still sit on top without hanging off.

I made this because the stock caps don't really work for terminators and bigger heroes — anything on a 40mm base ends up wobbling or just not fitting. The grooves on the sides are for your thumb so you can still spin the handle the way you normally would.

Prints flat on the build plate with no supports. Takes something between 15 and 30 minutes. I've run it in PLA, PETG and ASA. All work fine.

Settings I use: 0.2mm layer height, 2-3 walls, 15% gyroid infill. Nothing special.

Fits the RGG 360° V2.

If you want a different base size — 25, 32, 50mm, whatever — leave a comment and I'll do the most-requested one next. Remixes are fine, just keep the credit.