iPhone Magsafe Stand
IridiumIO
Shared by
Boost
19
30
29
Print Profile(1)
0.28mm layer, 2 walls, 15% infill
1.4 h
1 plate
Boost
19
30
29
2
127
153
Released
Description
print 100% infill at 8mm height to get a "heavy" stand, for lower parts 8% infill gyroid will do the job.
Will fit cheap amazon Magsafecharger too like https://www.amazon.de/gp/product/B095BZFX4L/
Comment & Rating (29)
All
Print Profile
0.28mm layer, 2 walls, 15% infill
Best one I've found! Thank you!
0
Reply
Print Profile
0.28mm layer, 2 walls, 15% infill
molto bello e rapido da stampare!
0
Reply
Print Profile
0.28mm layer, 2 walls, 15% infill
e perfetto! non mi fa dare 5 stelle ! per un bug ma valutate voi! il fir del mag safe e perfetto e la stampa e bellissma !
0
Reply
Print Profile
0.28mm layer, 2 walls, 15% infill
printed with sunlu clear PLA only change to the profile was a 5 loop skirt and it came out perfect. Fully functional in both portrait and landscape with my 14 pro max.
0
Reply
Print Profile
0.28mm layer, 2 walls, 15% infill
Nice print. Thanks for the design.
1
Reply
Print Profile
0.28mm layer, 2 walls, 15% infill
prints well
0
Reply
Print Profile
0.28mm layer, 2 walls, 15% infill
Very basic model but it ended up causing the print to go better than some other models I've tried. I like that the visible front of the piece is printed on the plate which makes it look the best it possibly can.
0
Reply
vary good!💪🏻
0
Reply
Print Profile
0.28mm layer, 2 walls, 15% infill
quality fit
0
Reply
Print Profile
0.28mm layer, 2 walls, 15% infill
top nur das Kabel könnte etwas besser fixiert werden
(Edited)0
Reply
The user shared this model, but is not the original creator of it.
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld