Minecraft Heart Stand

Just a little pixel heart for your desk. Prints quick, looks great, makes a solid gift for anyone who grew up on Minecraft (or still plays it — no judgment).

Size

• Width: 100 mm
• Height: 90 mm (heart only)
• Thickness: 10.5 mm

Sits nicely on a shelf or monitor stand without taking over the desk.

Print settings

• Plates: 2 (one for the heart, one for the base)
• Layer height: 0.2 mm
• Infill: 15%
• Material: PLA
• Supports: none, prints flat

Nothing fancy — should work on pretty much any printer.

Colors

With AMS (or any multi-material setup) Load red, black and white, hit print. That's how the photos were done and it comes out clean.

Without AMS I'd skip manual filament swaps on this one — the colors are scattered across the heart at different heights and you'd be babysitting the printer forever. Two better options:

1. Single color — print the whole thing in one color and leave it. Looks surprisingly good in all-black or all-white.
2. Paint it — print in one color and add the red and white pixels with acrylics afterwards. Takes 10 minutes and the result is honestly hard to tell apart from a multi-material print.