350x350mm 8mm thick Bed alignment brackets by Ryxxi_makes

Ryxxi_makes

3D Printer>3D Printer Parts

Print Profile(0)

Add the first print profile to earn points

Boost

Released

Description

I printed these in high temp Nylon CF

can either drill holes into the aluminium bed, tap them

or use high temp silicone

or high temp double sided tape

or same adhesive magnet that is used for most poei build plates.

bed

alignment

seckitsktank

Comment & Rating (2)

@umongusgod

Dang your first printer was an x1c?!? I had to go threw the depths of hell with the ender 3 pro lol. Before I finally got an x1c and p1s

(Edited)

@ole4isu

I don't know much about printers but I have an X1-C and I find placement of the bed plate is "finicky" between those 2 little low profile ramps in the corners. Does this replace those? I assume to have to remove them and install these in their place? Drilling and tapping sounds like the RIGHT way to do this but I don't think I have the skill set, patience, or time to disassemble, modify, and reassemble. Will tape or adhesive work well? Is this model compatible with the X1-C? or did you design it for a different device?

No more