Wolf

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 124.64x200mm in size

You may print at higher layer heights below the Base Thickness of 0.48mm
The Max allowed Thickness is 2.24mm and the Actual Thickness is 2.24mm

    #000000 PLA+ Sunlu Black  Transmission Distance: 0.6
    #d22332 PLA+ Sunlu Red  Transmission Distance: 6
    #565d65 PLA+ Sunlu Grey  Transmission Distance: 2
    #ff7713 PLA+ Sunlu Sunny Orange  Transmission Distance: 8
    #ffd500 PLA+ Sunlu Pure Yellow  Transmission Distance: 5
This print uses 5 unique filaments

Swap Instructions:
    Start with Black
    At layer #8 (0.72mm) swap to Red
    At layer #10 (0.88mm) swap to Grey
    At layer #11 (0.96mm) swap to Red
    At layer #16 (1.36mm) swap to Sunny Orange
    At layer #21 (1.76mm) swap to Pure Yellow for the rest.
 

This is my first attempt at a hueforge and i was happy with it so i thought id share.