Search models, users, collections, and posts
Touch Light Base Plate
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 0% infill
Designer
16 min
1 plate
Open in Bambu Studio
Boost
1
2
0
0
4
1
Released
Description
I needed a way to attach an LED Light Bar base without using 2 sided tape or glue.
Print using your normal settings…no infill.
Print Time: 30 min.
Base is snap fit, no glue needed.
25cm Led Touch Control Rotating Table Lamp from Temu: https://bit.ly/3E4W5eP
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)