Safety PPE Holder for Desks
Boost
9
24
2
Print Profile(2)
0.2mm layer, 2 walls, 10% infill, gyroid, skirt, normal auto supports
Designer
7.6 h
2 plates
0.2mm layer, 2 walls, 10% infill
Designer
5.6 h
2 plates
Boost
9
24
2
0
12
8
Released
Description
UPDATED VERSION 2 CAN BE FOUND HERE
- This version has multiple improvements which can be found in the description.
A place to hold your ear plugs, safety glasses, and gloves all in one place, while keeping the gloves off the desktop if you get them dirty!
Adjustable clamp for desks up to 1.5 inches thick.
Note: Be careful when tightening screw to hold onto desk, over torquing can cause the bottom part of the clamp to crack.
Glasses tray is 3in x 6in.
I printed mine in the orientation below, default auto normal supports in bambu slicer, after it cooled off for a while the supports came of easily.
Screw was printed from the head up.
Comment & Rating (2)
All
Print Profile
0.2mm layer, 2 walls, 10% infill, gyroid, skirt, normal auto supports
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill, gyroid, skirt, normal auto supports
Really good print. Had to re-print the screw at 99% to get a better fit. Would print again
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld