Top glass raisers for P1S and probably X1C.
PLA but whatever filament should work.
printed using 0.4mm nozzle all default settings from Orca slicer. Print the same way as the pictures or on the side using supports. Both sides should work. I printed them the same way as pictured.
Confirm the measurements before printing. I lost the original file and I had to make them again for a friend. I haven't printed them since the remake.
Took me around 2.5h and 70g of filament to print. I used 15% gyroid infill. I am sure you can reduce the amount of filament needed by modifying the settings. It's up to you.
The raisers feel slippery on the case and if I had to make them again I would add tiny clips under it to clip to the printer frame. I'll probably update this model when I am off work in a few days. Until then enjoy! ;)