MIKA3D Cardboard Ring For Bambu AMS or Filament Dryers
Remixed by
Copyright Claim
MIKA3D Cardboard Ring For Bambu AMS or Filament Dryers
Remixed by
Boost
2
7
4
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
23 min
1 plate
Boost
2
7
4
0
35
47
Released
Description
Made to fit OEM MIKA3D Cardboard Spools.
Walls: 3
Res: 2
Infill: 0
Size is 195mm
Print in PETG or better if you use it in a dryer.
Comment & Rating (4)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
the print came out fine and it fits on the Mika3d cardboard spool properly, but it still seems just a bit too small for the AMS. This causes it to slip some and not retract full at the end of a print. I’ll probably take this model and thicken it up a little to help it out, but overall not quite the fix I was hoping for.
0
Reply
I didn't put up that profile, try the specs I posted.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld