Search models, users, collections, and posts
Spoon Holder
IP Report
Print Profile(0)
Add the first print profile to earn points
Boost
1
3
0
0
2
0
Released
Description
Introduction
This is a first attempt at making a spoon holder. I was asked to make one to replace a ceramic spoon holder that kept cracking against the counter top.
Printing
This print uses all standard print settings. It prints flat on the build plate just as it would sit on a counter top. See specific settings below.
| Material | PETG |
| Nozzle Temperature: | 240C |
| Bed Temperature: | 85C |
| Layer Height: | .2mm |
| Infill: | 15% |
| Supports: | None |
| Brim and Skirt: | None |
License
This user content is licensed under a
Creative Commons Attribution
Comment & Rating (0)