Search models, users, collections, and posts
Vermilio
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
12.2 h
5 plates
Open in Bambu Studio
Boost
3
4
0
0
1
1
Released
Description
Content has been automatically translated.
Notes:
- After printing, it seemed a bit small, so it is recommended to change the scale to 117% before printing
- Coat? Or vest? The strap in the middle didn't print well, so I ended up removing it and plan to buy cotton rope to attach later. However, both versions are still included in the 3mf file
- Due to the center of gravity, directly attaching the flame to the right hand will cause the model to fall, but after hanging the left hand's branch on the flame, it can maintain a peculiar balance It's best to fix it with glue after painting
- The hand joint needs slight trimming
4/18/2026: The main body of the figure was resin printed, repainted, and the preview was updated
For coloring, you can refer to Kotobukiya's Barmilio model, and:
License
This user content is licensed under a Standard Digital File License.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)