Trash Bin and Rim
Copyright Claim
Trash Bin and Rim
Boost
52
88
20
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
17.7 h
2 plates
Open in Bambu Studio
Boost
52
88
20
2
250
238
Released
Description
A trashbin made to take up as much space as possible on the Bambu Lab X1/P1 series. The lip slides on but can be pretty snug, if tolerances are a concern, size up the rim 1-2% or size down the bin 1-2%
Because the outside bin is ribbed, slicing time could take a bit, but done so to reduce filament usage while keeping the bin some rigidity.
Comment & Rating (20)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
nice design!!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Great print. Did it in dual silk filament
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Holds all of my printing scrap to be recycled later! :D
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Share AlikeRelated Models
© 2024 MakerWorld