Wizard Staff

About

Staff for wizards, witches, and mages.  Wonderful addition to fantasy cosplay.

Print & Assembly Instructions

The crown is the only piece that requires supports.  Print it upside down.  Print two of the middle end pieces.  All shaft pieces should be printed vertically.  I recommend just using an inner brim.  If you have bed adhesion issues, maybe use an outer brim or use glue.

The inner rods work well to make the staff much stronger than other staffs that screw together.  Everything must be glued together.

The assembly is pretty self explanatory and obvious once all the pieces are printed out.  Start with the bottom shaft and insert the inner rod and glue.  Add the end middle piece, then the middle piece, then the end middle piece, and finally the top piece.  Add inner rods and glue along the way.  This completes the shaft.  I recommend gluing the gem to the cage first and allowing to dry, then gluing the cage and gem to the shaft.

The staff can be easily lengthened by simply printing and adding more middle pieces to get the desired length.

Connect with Me

I'm excited to share my 3D designs with the community, and I'd love to see your prints!  If you share them on Instagram, please consider tagging me, so I can celebrate your amazing prints!

Instagram: @OriginalClassicAdam

YouTube: @OriginalClassicAdam

Friendly Reminder and Disclaimer

These models are provided as-is, so please take care when using them and adapt as needed. Please use common sense and caution when printing or assembling.  I cannot make any guarantees about their performance or safety.  By downloading or using these files, you accept responsibility for any outcomes.