Mask Display Stand
Copyright Claim
Mask Display Stand
Boost
26
28
5
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
4.5 h
2 plates
Boost
26
28
5
0
55
40
Released
Description
Halloween Mask or Helmet display stand. I have not tested as a helmet stand but may work. Cut PVC pipe to desired height.
Printed with 25 percent infill for the top piece.
Comment & Rating (5)
All
there is no center post for this model its just the base and the top thats it
0
Reply
"cut PVC pipe to desired height". That´s your center post
1
Reply
reading is fundamental...
1
Reply
The top piece is solid. Is there supposed to be a hole for the pvc to slide into?
The designer has replied
0
Reply
yes there should be a hole
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld