big Headphone Hanger for smaller Printers
Remixed by
Boost
15
38
4
Print Profile(1)
0.2mm layer, 2 walls, 15% infill, PETG
Designer
4.9 h
2 plates
Open in Bambu Studio
Boost
15
38
4
0
92
112
Released
Description
I divided the headphone holder for smaller printers into 3 parts.
I also made them a bit taller so that large headphones don't hit the table.
I recommend PETG as an interface material.
Comment & Rating (4)
All
Print Profile
0.2mm layer, 2 walls, 15% infill, PETG
Really cool! Being in several parts and printing it in PETG ended up a bit tricky putting together at the one spot. Had to trim and heat it to get it to go together and even then it didn't go all the way. Still better than how I had my headphones. Thanks for sharing this! 👍
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, PETG
The pegs for the 2 piece top didn't fit very well. other than that it was good. Ditn't take a whole lot to make them fit. Cleaned the holes out with a slightly larger drill bit and as great.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, PETG
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill, PETG
0
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld