Lechuza cover with filter
Boost
7
17
3
Print Profile(2)
20mm depth filter - 0.28mm layer, 2 walls, 15% infill
Designer
35 min
1 plate
15mm depth filter - 0.28mm layer, 2 walls, 15% infill
Designer
31 min
1 plate
Boost
7
17
3
2
17
20
Released
Description
Replacement for the original lechuza balconera cap. Enabled direct watering without removing the cap.
The original cap is anoying as you have to remove it every time you want to watering your plants. I wasnt happy with the other solutions I found online because the water flow is too poor, so i made one myself. Also i made it quite snappy so my kids are not able to pull out the watering level tube anymore :)
PLA could work if your plants cover the cap from direct sun. I will print it again in ASA.
Supports are required for the filter part.
I made a 15mm depth filter and a 20 mm depth one to make watering even more comfortable.
Comment & Rating (3)
All
Boosted
Print Profile
20mm depth filter - 0.28mm layer, 2 walls, 15% infill
Looking good, Ty
0
Reply
Print Profile
20mm depth filter - 0.28mm layer, 2 walls, 15% infill
1
Reply
Print Profile
20mm depth filter - 0.28mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld