Summary

My wife needed a phone stand for a charger she purchased (Insignia Quick Charger) so I felt none of the available entries on Thingiverse fit the bill so I made one. Works with Insignia phone charging pad (about 95mm diameter) Tested with Samsung S8+ and S10 models. I left the opening for the charger a tiny bit larger so the charging pad could easily be removed. I used tiny bits of poster putty to adhere the pad to the back of the stand but it isn't necessary. Printed with no support.

Rotate the stand (from the default model position) 90 degrees on the X axis so the base is lying on the bottom of the bed.

Print Settings

Printer Brand:

LulzBot

                                            Printer:                      
TAZ 6

Rafts:

Doesn't Matter

                                            Supports:                      
No

Resolution:

0.14

                                            Infill:                      
20%

Filament:

Verbatim PLA

                Translucent                    
                        Notes:                     
Printed with no support.  Works with Insignia phone charging pad (about 95mm diameter) Tested with Samsung S8+ and S10 models. I left the opening for the charger a tiny bit larger so the charging pad could easily be removed.  I used tiny bits of poster putty to adhere the pad to the back of the stand but it isn't necessary.