PS5 skates disk edition
Boost
109
161
50
Print Profile(3)
OFFICIAL 0.2mm layer, 3 walls, 15% infill
Designer
3.1 h
2 plates
0.2mm layer, 3 walls, 15% infill
2.1 h
1 plate
0.2mm layer, 3 walls, 15% infill
1.5 h
1 plate
Open in Bambu Studio
Boost
109
161
50
3
294
308
Released
Description
I have designed these PS5 skates for a buddy of mine. He was super happy about them so I am assuming they fit well enough
Comment & Rating (50)
All
Print Profile
OFFICIAL 0.2mm layer, 3 walls, 15% infill
fits like a glove! works better than what comes in the box
The designer has replied
1
Reply
Very nice print ! Thanks for sharing and rating
0
Reply
Printed perfect.
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
printed fine
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
came out great and great use case
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
1
Reply
Thanks for sharing and rating, it looks great !
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
(Edited)
1
Reply
Look really good !
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
first skate prints well despite a small adhesion problem in our print
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
does not fit on PlayStation 5 it’s too big
1
Reply
Does your PS5 have an optical drive? If not then you need a Digital edition set of skates.
0
Reply
Replying to @Nairnwatt
mines disk version and are to big
0
Reply
have you found a file that works because i have the same issue as you do
0
Reply
Just a heads up there is 2 different versions of the ps5 disc system. The original is a bit wider (this is for that) and a slim that it will not fit. great overall print from the creator just figure out what version you have before you print.
1
Reply
License
This user content is licensed under a
Creative Commons AttributionRelated Models
© 2024 MakerWorld