Pumpkin - Tealight
Copyright Claim
Pumpkin - Tealight
Boost
19
31
14
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.9 h
2 plates
Open in Bambu Studio
Boost
19
31
14
0
81
80
Released
Description
Tealight Pumpkin with removable lid, lid and main body have nubs to align and stay connected. 3 part print no supports needed.
I printed with 5 walls to remove any infill on the main body.
Comment & Rating (14)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed great. I had some orange ABS I used for the pumpkin and green PLA for the stem. seems a bit small for a tea light so next time I’d scale it up a bit but love the print. quarter used for size comparison.
1
Reply
I'm kinda bummed that the picture shows two pumpkins but the file only contains the single?
The designer has replied
1
Reply
I can upload the other too, was working to eliminate supports on that model beforehand but I’ll revision it once I’ve been able to.
Thanks!
2
Reply
Replying to @ThisJustn
:^D
1
Reply
Replying to @ThisJustn
any update on this?
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Hat
Other Issues:hat Beim 2 mal super funktioniert
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld