Corner clamp - stackable
Copyright Claim
Corner clamp - stackable
Boost
54
160
10
Print Profile(1)
0.2mm layer, 4 walls, 30% infill
Designer
5.4 h
1 plate
Boost
54
160
10
1
110
73
Released
Description
Settings:
- 0.20mm Standard
+custom settings: - Wall loops min. 4
- Outer wall: 60 mm/s
- Infill min. 30 %
- supports on - but don't support bridges see below
- PETG preferred
Comment & Rating (10)
All
Print Profile
0.2mm layer, 4 walls, 30% infill
My first attempt was not successful due to “Don’t support bridges” being checked. I unchecked that and I also used PLA as the support interface as this part was made in PETG.
1
Reply
Print Profile
0.2mm layer, 4 walls, 30% infill
black ABS works beautifully!
1
Reply
Print Profile
0.2mm layer, 4 walls, 30% infill
Working well - suggest disabling Gyroid as it’s such a time suck and not providing any additional strength here. Great little item though :)
0
Reply
Print Profile
0.2mm layer, 4 walls, 30% infill
bestens
0
Reply
Print Profile
0.2mm layer, 4 walls, 30% infill
0
Reply
Boosted
Print Profile
0.2mm layer, 4 walls, 30% infill
0
Reply
Print Profile
0.2mm layer, 4 walls, 30% infill
0
Reply
Print Profile
0.2mm layer, 4 walls, 30% infill
0
Reply
Print Profile
0.2mm layer, 4 walls, 30% infill
0
Reply
Print Profile
0.2mm layer, 4 walls, 30% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld