Search models, users, collections, and posts
Spool Drawer
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
2.8 h
1 plate
Open in Bambu Studio
Boost
5
11
0
0
10
2
Released
Description
This is a bit of tight fit drawer to make use of your empties.
200mm wide and 57mm high to match most spools.
I recommend that you reduce the height by 1mm if it's too
tight. I prefer it tight and it will no doubt loosen over time anyway.
You could adapt or fine tune it a little. Big changes will
probably require a rethink and a new model.
It prints in PLA in just over 2 ½ hours or about 1 ½ hours in ludicrous mode
on my A1 which I find myself using more and more without too many issues
if any.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)