Summary

Updated with V2 and variants:

• Wall and Floor thickness reduced.
• Depth reduced to 18mm total
• Brace thickness increased so raise height in draw (sits higher on dividers)

Variants:

Variants are available with 3, 6 and 12 compartments.

I would suspect that no more than 6 compartments would be useable, but included in case someone has a need.

Note: Pictures of printed model are v1 - depth slightly reduced from pictures.

Original Description

Remodelled with larger spacing between compartments, to allow it to sit on top of the physical dividers installed into a Raaco component draw.

Results in 6 compartments for components - 3 from the 3d printed part and 3 from the divider function themselves.

Note that they always sit at the same depth due to hooking onto the dividers, but there isn't that much space in the bottom compartments, so very definitely for small component storage. I will probably generate some more variants at different depths so you can choose.

Instructions:

Simply install 2 dividers ( or print some if you don't have any ) and then drop in this print over the top.

See pictures for example use.

Please note that these are not identical in both directions. The end with the slightly larger radius rounded ends is the back - try it the other way if its not a perfect fit.

Printing was 0.28 layer height, 15% infill and no supports or anything - print with bottom of the draws on the bed.

PS - If you don't have any dividers with your unit, there are several models about and one I created here: https://www.thingiverse.com/thing:5330776