I made this rack to hold a 10-pack of hobby syringes that I use to hold solvents, lubricants, glues, etc.

If you buy this syringe pack, you should definitely print this holder. https://www.amazon.com/10-Pack-Syringe-Needles-Applicator/dp/B01HFTYINS/ref=sr_1_10?ie=UTF8&qid=1505278113&sr=8-10&keywords=hobby+syringe

This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/8DWTz4o14BF

Print Settings

Printer Brand:

Ultimaker

Printer:

Rafts:

No

Supports:

Resolution:

0.1mm

Infill:

Notes:

You'll need supports on the tray edges and on the rectangular tray opening in the holder, but I removed the supports from the actual holes. I didn't need them.rnrnThis uses thefull bed width on an UM2 Extended+ so make sure you turn off brim.

Category: Tool Holders & Boxes