Hey MakerWorld! Are you sick of the plain old boring P1S? Enhance its beauty with this custom decal kit!
You can print out these decals in any filament color you have to give your printer a bit of uniqueness. This kit comes with perfectly sized decals for the front, sides, front door handle, and top glass handle. The sides may work for the X1C, I'm not too sure!
Applying your decals is simple!
Step 1: Print out decals.
Step 2: Tape over decals with clear scotch tape
Step 3: Flex your plate to pop off the decals. It may be necessary to use the Bambu scraper to pop them off as you peel back the tape.
Step 4: Apply a glue stick by dabbing the backs of the decals. Glue sticks are washable with water and will not harm the cosmetic finish of your printer.
Step 5: Line up decals and press onto surface.
Step 6: Wait a couple hours, then carefully remove the tape at a sharp angle.
Step 7: Enjoy the new personalized look of your printer!
The larger Bambu logo and words are inverted because they are large enough to put on by hand and the texture of the build plate looks better in my opinion.