Search models, users, collections, and posts
He is Risen Egg
IP Report
This model is created by Image to 3D
Make Your Model
Print Profile(1)
0.12mm layer, 3 walls, 15% infill
Designer
14.9 h
1 plate
Open in Bambu Studio
Boost
9
29
0
0
10
2
Released
Description
This is a 3D printable hollow tomb designed in an egg shape, made to house a small USB light in the back for a soft glowing effect.
The back includes a hole for inserting a small USB light, which creates a beautiful backlit effect behind the cross.
Printing Notes:
- Designed for FDM printing
- Flat bottom for easy bed adhesion
- Works well at 0.12 layer height for detail
⚠️ Support Tip (Important):
The support to the left of Mary connects to the support underneath her, making it a bit tricky to remove cleanly. When removing supports, go slow in this area.
I ended up breaking part of the support and leaving a small piece underneath her to avoid damaging the figure.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (0)