The Witch card
Copyright Claim
The Witch card
Boost
28
40
4
Print Profile(2)
0.08mm layer, 1 walls, 100% infill
Designer
58 min
1 plate
200mm, 0.04mm layer, 1 walls, 100% infill
4.4 h
1 plate
Open in Bambu Studio
Boost
28
40
4
2
71
13
Released
Description
*created with filament painting technique using hueforge software. Tried new option
Remember if you want to scale, do it only with x and y axis, z must be the same as original.
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
Filaments Used:
PLA BambuLab Basic Black
PLA BambuLab Basic Beige/grey
PLA BambuLab Basic Jade White
PLA BambuLab Basic Red
Swap Instructions:
Start with Black
At layer #6 (0.56mm) swap to Beige
At layer #7 (0.64mm) swap to Jade White
At layer #12 (1.04mm) swap to Red for the rest.
Comment & Rating (4)
All
Print Profile
0.08mm layer, 1 walls, 100% infill
cool print, wish it was a little thicker but turned out great
0
Reply
Print Profile
200mm, 0.04mm layer, 1 walls, 100% infill
Sehr schön...
0
Reply
Boosted
Print Profile
200mm, 0.04mm layer, 1 walls, 100% infill
Printed great! I didn't use the exact same filament but it seems my alternates were close enough - actually used a PLA Silk Silver for the "light gray" and it gave it an interesting sheen in the right light. My wife loves it!
0
Reply
Print Profile
0.08mm layer, 1 walls, 100% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons AttributionRelated Models
© 2024 MakerWorld