Superman Logo Keychain - DC Comics Man of Steel key chain

.4mm Nozzle, 0.2mm Layer Height instructions:
Start with Blue Filament layers 0 through 13

Swap to Yellow Filament at 2.8mm (Layer 14)

Swap to Red Filament at 3.4mm (Layer 17)

Make sure you're flushing volumes are good – there is only 3 layers of yellow, so you need to flush Blue to Yellow pretty well to ensure that the blue does not bleed into the yellow and the yellow is the proper level of brightness.

----------------

If you like my stuff, check out my patreon

https://www.patreon.com/LilacRage