Some printers have feets on their vats, so you can set them to any table surface, Phrozen sonic mini 4K doesn't have that and I always have trouble finding a good spot to lay it down between dripping leftover resin back to resin bottle and cleaning the vat.

Feet are ment to be pressure fitted, but you can use a drop of glue if they are not tight. I had to use hobby knife a little bit to trip the edges of the feet to get them to fit.

This is a remix from @guelz's design

Print Settings

Printer Brand:

Creality

Printer:

Ender 3

Rafts:

No

Supports:

No

Resolution:

0.2

Infill:

10%

Filament:

random pla white

Notes:

Feet takes 20 minutes to print with 60mm/s speed and uses 2 grams (0.69 meters) of filament.
Vat holder takes little under 3 hours to print and uses 24 grams (8 meters) of filament. You don't need supports, bridging is just a short one. I accidentally made mine with 3 walls, you might want to increase to 4 or 5 walls to get even more rigid print and it won't increase the use of filament or time that much.

Category: 3D Printer Accessories