This brush holder, intended for cleaning the nozzle on the JGaurora a5 (a5s) printer, comes with a START gcode script to position the nozzle conveniently for cleaning with the recommended copper brush from AliExpress:
Use this GCODE at the start:
; -- START GCODE --
G21 ;set units to millimetres
G90 ;set to absolute positioning
M106 S0 ;set fan speed to zero (turned off)
G28 ;home all axis
M420 S1 ;turn on mesh bed levelling if enabled in firmware
G92 E0 ;zero the extruded length
G1 X0 Y310 Z10 E-5.0 F10000 ;start wipe pos and retract fillement prevent oozing
G1 X30 Y310 Z5 F20000 ;start wipe pos
G1 X0 Y310 Z5 F20000 ;start wipe pos
G1 X30 Y310 Z5 F20000 ;start wipe pos
G1 X0 Y310 Z5 F20000 ;start wipe pos
G1 X30 Y310 Z5 F20000 ;start wipe pos
G1 X0 Y310 Z5 F20000 ;start wipe pos
G1 X30 Y310 Z5 F20000 ;start wipe pos
G1 X0 Y310 Z5 F20000 ;start wipe pos
G1 X30 Y310 Z5 F20000 ;start wipe pos
G1 X0 Y0 Z1 F10000 ;reset pos
G1 Z1 F1000 ;move up slightly
G1 X60.0 Z0 E9.0 F1000.0 ;intro line
G1 X100.0 E21.5 F1000.0 ;continue line
G92 E0 ;zero the extruded length again
; -- end of START GCODE --
Please be cautious while using, as I am not liable for any potential damages to the printer.
Printer Brand:
JGAurora
Printer:
JGAurora A5 & A5S
Rafts:
Doesn't Matter
Supports:
No
Resolution:
.3mm or above
Infill:
≥ 15%
Notes:
High temp material, PLA will morph cause of the heated bed
I recommend PET, PETG
Category: 3D Printer Accessories