Xbox controller wall mount by motor-fuzzi

motor-fuzzi

Tools>Organizers

Print Profile(3)

All

P1S

P1P

X1 Carbon

X1E

A1 mini

0.2mm layer, 3 walls, 25% infill

1.5 h

1 plate

4.8(33)

Lying on backside - 0.12mm layer, 3 walls, 8% infill

2 h

1 plate

5.0(4)

0.24mm layer, 3 walls, 15% infill

1.6 h

1 plate

4.0(2)

Boost

261

301

Released

Description

X-Box controller wall mount.

Only one screw needed. No support for print needed.

There is also a version of this which can be clamped to a table:
Xbox controller desk mount

Comment & Rating (45)

@azketta

Print Profile

0.2mm layer, 3 walls, 25% infill

I printed it to hold both my switch and Luna controllers with silk PLA; I’m going to print more for a PS5 (which it also fit), and more. I’ll update photos once I do. Pros: fits many controllers, mountable, love the more ‘decorative’ support beam (both nicely engineered & more aesthetically pleasing) Cons: Scree hole not flat (kinda fixes as the screw goes in) & the bottom prints sharp on transitions; perhaps this will be smoother with more layers or another material…

@CharraLabs

Can you make a design, where the controller hangs from the table, by having a screw to tighten the gap between two 3d printed shapes, so that you can stick the hanger on to the table. Is that possible?

The designer has replied

@CharraLabs

something like this: https://makerworld.com/en/models/32520#profileId-29196 But instead of having it for Headsets, you put a xbox elite 2 stand there

@motorfuzzi

I have created a version with a clamp to the desk, as you suggested.... I hope you like it (and give it 5 stars) have fun... https://makerworld.com/de/models/128315#profileId-138911