Headphone Stand by LayerCake

LayerCake

Tools>Gadgets

Print Profile(2)

All

X1 Carbon

P1S

P1P

X1E

A1 mini

Single Model

Designer

3.6 h

1 plate

4.8(42)

Split Model

Designer

4.9 h

2 plates

4.9(7)

Boost

126

497

461

Released

Description

Since this stand is pretty big I split it into two pieces for smaller printers, but it can also be printed as one large print on bigger printers.

Notes

Made with the personal version of Autodesk Fusion 360 therefore non commercial only.

Source file included.

Comment & Rating (51)

@J.Foxwood

Print Profile

Single Model

Nice model, thanks

@Matias.Randone

Print Profile

Single Model

molto bello!!!

@zach.bench

Print Profile

Split Model

works great

@danndem

Print Profile

Single Model

Printed in tri color silk. Got a bit of ringing but it's probably just my calibration.

@lordtime

i have weirdest experience with this model , do not blaming author :) but quite and interesting. exactly on the same moment 2 filaments made terrible clog on x1c 0.4 mm nozzle, i had to remove print head and remove clog with small wrench by heating with lighter, it was SUNLU PLA+... then i started to print with ANYCUBIC PETG and voila - same place and new even worse clog , this time filament even stuck in extruder so i had to disassemble even extruder. basically it made my day busy :) all ican say both filament were installed in same AMS slot 4 . may be that the issues . posting here as may be someone can give a clue what may happened ...