Picture Hanger
Copyright Claim
Picture Hanger
Boost
5
6
2
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
11 min
1 plate
Boost
5
6
2
0
13
41
Released
Description
Make sure you have good layer adhesion and test the print, don't blame me for a dropped picture frame.
Required Hardware
- 1 Large Tesa Powerstrip
Notes
Made with the personal version of Autodesk Fusion 360 therefore non commercial only.
Source file included.
Comment & Rating (2)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
It`s a good Print Profile but I would say that the first Layer got printed a little too fast.
In total it´s a good profile. :)
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld