HYDROPONIC WATER SPREADER

This Water Spreader for Hydroponics is 100% designed by me. Assembly is straightforward; just push it into the coupler until it stops. No sanding needed for a good fit. It doesn't need high-quality printing or be watertight. I used cuboid infill at 15%, but lightning infill could work too. Consider a heat-resistant material if exposed to the sun without water cooling.

In the pictures, you'll notice a white PVC tube connected to a DC pump at the bottom, responsible for water circulation. The water flow might appear weak because I intentionally underpowered the water pump to prolong its lifespan, but rest assured, the 3D printed part can still effectively spread the water.

Additionally, you may observe water leaking from around the 6-inch PVC tube. That's entirely my fault due to impatience during assembly, as I was too hasty with silicone for the coupler. However, even without it, if you simply drill a hole in the base of the pump, all the water goes back to where it was, ensuring water distribution to all the plants.