LIGHTBOX MEW POKEMON
Copyright Claim
LIGHTBOX MEW POKEMON
Boost
32
41
6
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
16.8 h
9 plates
Open in Bambu Studio
Boost
32
41
6
0
37
15
Released
Description
LIGHTBOX MEW POKEMON
Comment & Rating (6)
All
This printed great except for the last slide. there was a lot of pieces that didn't connect to the last piece and it had to get printed multiple times to get the right effect with the box. Other then that it came out great!
The designer has replied
0
Reply
I do have a question though, the bar and 4 squares on the print, where exactly are those supposed to go? They're to big for the squares on the side and the bar in the back .
0
Reply
Replying to @dreaami25
Did you figure it out?
0
Reply
I'm sorry but I made the last piece in a hurry and I didn't check the pieces well. and I'm also sorry if I reply late due to work.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld