After using several versions of poop chutes, I've found that the various sizes of poop often clog up the narrow slide during prints with a lot of color changes. I've created this extra wide version which has not had an issue with any oversized poop or clogging as much as I've tried. Designed to drop poop directly down into a trash can, with a downslope to provide the poop with additional momentum to the end of the escape hatch. Due to build volume limitations, this is printed in two pieces on the same plate. Simply glue the drop to the bottom of the poop chute when complete. Snug it up against the back of the printer, or two slots are available for 18mm magnets.