Screw on PTFE Tube Guide for Sunlu FilaDryer S1 Remixed by L3D

Remixed by

L3D

3D Printer>3D Printer Accessories

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 2 walls, 15% infill

1.8 h

1 plate

4.7(6)

Open in Bambu Studio

Boost

Released

Description

I needed the PTFE connector in the upwards position and for it to be fixed to the dryer.

I advise printing it in ABS or ASA because of the heat chamber, but i did it in PETG.
It would possibly smart to make a thermal insulation between the print and heater.

Print Settings

Supports:
- Yes, On build plate only
Resolution:
- .20mm
Infill:
- 15%
Filament material:
- PETG

Comment & Rating (7)

@Hawk1252

Print Profile

0.2mm layer, 2 walls, 15% infill

Great Print.

@vonWalden

Print Profile

0.2mm layer, 2 walls, 15% infill

Other Issues:My hotend clogged twice. 😔 I will try to print this model with only PETG to see if the PLA/PETG switching is causing my issues. It's my first try to use PLA as support.

The designer has replied

@ipdoyou

I've printed it with standard support settings using all PETG, and the tweeked PLA support profile. You might, if it clogs again, you might try resetting the support parameters and use all PETG. it will leave some minor surface imperfections but only seen from below looking up.