Looking for a faster way to add pops of color to your print?
Slide in pieces of filament to add pops of color to this 12 ounce can koozie. The original model contains 6 wave sections, but I have also included a version with only 3 wave sections. Each section requires 6 pieces of filament. By using pieces of filament instead of multiple filaments on your AMS, we save days of print time (2.5 hours vs 3 days+)!
Color Ideas:
Print Settings
This model was specifically designed for a 0.4mm nozzle. I have not tested a larger nozzle, but I suspect that using a larger nozzle may allow the pieces of filament to fall out. The larger nozzle may not be able to get enough material around the front side of the holes that are shown below. This material is the only thing that holds in the pieces of filament.
If you print this model with a larger nozzle, please let me know about your experience so the community can have updated information!
Assembly Instructions
Pieces of 1.75mm filament will be needed. Slide a piece into each of the holes and cut it flush with the top of the koozie. Depending on the version chosen, it will require either 18 or 36 pieces of filament.
The following filaments were used in the pictures above: