This is one of 3 prints this type I tried. All three had the same issue. I'm just learning and could be missing something but after printing, the egg fit but the rabbit would not stand without tipping to the side. The Kinder eggs in my area have a lip attaching the 2pieces together and it's possible that lip was stopping it from fully being centered. I tried a real egg, Oreo egg, Kinder, and Cadbury egg, none fit. I wasn't able to figure out a solution but didn't invest much time.
thank you for the review! I don't know for the other egg but if the problem is tipping to the side scaling only the z axis can do the trick I think like a 20% more
0.2mm layer, 2 walls, 15% infill for kindersuprise
This is one of 3 prints this type I tried. All three had the same issue. I'm just learning and could be missing something but after printing, the egg fit but the rabbit would not stand without tipping to the side. The Kinder eggs in my area have a lip attaching the 2pieces together and it's possible that lip was stopping it from fully being centered. I wasn't able to figure out a solution but didn't invest much time.